User`s guide

Configure Access to Digi Passport via SSH
Chapter 2 Getting Started 31
Configure Access to Digi Passport via SSH
Access to the Digi Passport unit's command line via SSH is enabled by
default (TCP port 22). The Port Access Menu and individual ports can be
configured for SSH. The Digi Passport unit supports Blowfish and 3DES
encryption methods for SSH.
Configure the Port Access Menu for SSH
1. Enter the IP address of the Digi Passport unit into the address bar of the
browser to access the web interface.
2. Log in as root, admin, or a member of the port administration group.
The default password for root is dbps, and the default password for
admin is admin.
3. Select Serial port > Configuration > Port access menu
configuration. The Port access configuration menu is displayed.
4. For Port access menu protocol, select SSH.
When enabled, the Log in on port access feature requires two logins,
once for access to the port access menu and again for the specific port.
If this feature is disabled the only login challenge is to the Port Access
Menu, though only permitted users can successfully connect to any spe-
cific port.
5. Click Save & apply.