User`s guide

Configmenu scripting
Chapter 16 Configuration Menu Interface 274
The “apply” command can be also run separately after saving all changes
Here is an example of adding a new remote port with a TCP port of 7005:
All other settings, such as remote port parameters, must be set to make the
remote port work correctly.
[root@Digi_Passport ~]# configmenu set /network/ip/ipconf2/
ipconf2/ip_mode=1 save
Set : /network/ip/ipconf2/ipconf2/ip_mode=static IP (1)
[root@Digi_Passport ~]# configmenu set /network/ip/ipconf2/
ipconf2/ip_addr=10.0.5.2 save
Set : /network/ip/ipconf2/ipconf2/ip_addr=10.0.5.2
[root@Digi_Passport ~]# configmenu apply
.............
Apply Done.
[root@Digi_Passport4 ~]# configmenu add rport 7005 save apply
Add : /serial/serial_config/ports/*5
Set : /serial/serial_config/ports/*5/hostmode/listening_port=7005
...
Save Done.
..
Apply Done.
[root@Digi_Passport4 ~]#
[root@Digi_Passport4 ~]# configmenu set \
/serial/serial_config/ports/*5/rport_param/dest_ip=192.168.1.2 \
/serial/serial_config/ports/*5/rport_param/dest_port=22 \
/serial/serial_config/ports/*5/rport_param/protocol=2 save apply
Set : /serial/serial_config/ports/*5/rport_param/
dest_ip=192.168.1.2
Set : /serial/serial_config/ports/*5/rport_param/dest_port=22
Set : /serial/serial_config/ports/*5/rport_param/protocol=SSH (2)
..
Save Done.
.
Apply Done.
[root@Digi_Passport4 ~]#