User`s guide

Clustering
Chapter 16 Configuration Menu Interface 264
Clustering
By default, clustered slave devices are configured using the Telnet protocol
and the following port parameters:
• bps=9600
• data bits=8
• parity=none
• stop bits=1
• flow control=none
When the master device autoconfigures a slave device, it simply imports
the information from the slave unit. To use other protocols or port
parameters, configure the slave unit with those parameters before
autoconfiguring.
Set Up Digi Passport for Clustering
To set up the Digi Passport unit for clustering:
1. Access the configuration menu.
2. Select Clustering configuration > Unit position.
3. Assign the unit as the master device. A new screen is displayed.
4. Enter the number 1 for the first slave unit.
5. Select Enable/Disable unit clustering > Enable.
6. Enter the values for Slave Unit IP, No. of ports, and Port
configuration.