User`s guide

Configure Master-Slave Port Clustering
Chapter 15 Port Clustering 222
Configure Master-Slave Port Clustering
Configuring the Digi Passport unit for port clustering requires these tasks:
• Configure all the Digi Passport serial ports.
• Assign one Digi Passport unit as the master clustering device; all other
Digi Passport units default to slave devices.
• Import the slave configuration to the Digi Passport unit’s master device.
Assign Master Clustering Mode
To assign a Digi Passport unit as the master cluster device, do the
following:
1. Access the Digi Passport unit through the web interface. This Digi
Passport unit will be the Master.
2. Select Clustering > Configuration.
3. For the Clustering mode setting, select Master. (By default, subsequent
Digi Passport units are configured in Slave mode.)
4. Click Save & apply.