User`s guide

Third-Party Power Controllers
Chapter 14 Power Controller 207
Locally connected ServerTech power controller
To install a locally connected ServerTech power controller, follow the steps
listed.
1. Connect the serial port of the ServerTech device to one of the serial
ports on the Passport using a standard Ethernet cable.
2. In the Web go to Power controller > Configuration. The page below
will open.
After adding the Power controller a page similar to the one below will be
displayed.
3. Select ServerTech from the Manufacturer pull down.
4. Select the serial port that the device is connected to, from the Port
menu list on the Add power controller page as shown below.