User`s guide

Managing Digi RPM from the Command Line
Chapter 14 Power Controller 204
Managing Digi RPM from the Command Line
The Digi RPM can be managed using ASCII commands. For information
about these commands, see the Digi Knowledge Base article
Quick reference to the RPM command line, at:
http://www.digi.com/support/kbase/kbaseresultdetl.jsp?id=866
Third-Party Power Controllers
In addition to the Digi RPM power controller, Digi supports several third-
party power controllers, including controllers manufactured by ServerTech
and BayTech. The serial-based controllers are configured in the same
manner as the Digi RPM, described previously. Additionally, Digi Passport
supports ServerTech network-enabled power strips. The additional steps
for configuring network-enabled power strips are described below.
Additional Configuration: Network-Enabled ServerTech Power Controller
Remote ServeTech Power Controller
To install a remote ServerTech power controller, follow the steps below.
1. In the Web go to Power controller > Configuration the page below
will open.
2. Select ServerTech from the Manufacturer drop down.