User`s guide

User Access for Power Controller
Chapter 14 Power Controller 199
Configure to Restrict Specific Users
To restrict specific users, select access for << Everyone>> and add the
restricted user by deselecting his or her access.
1. Log in to the Digi Passport unit (username root, password dbps).
2. Select Power Controller > Configuration > Outlets > outlet number
to configure.
3. Select the port to configure to the outlet. If it is a non-serial device select
None.
4. Edit the outlet title. If there is a serial port, the port title will appear and
cannot be edited from this screen.
5. Click Save & apply.
6. Check Everyone and click Save to flash.
7. Enter the username that will NOT have access, deselect the Access
types that are restricted, and click Add.
• Port is access to the port.
• Monitor is access to sniff.
• Power is access to the power management.
8. Click Save to flash and repeat steps 7 and 8 for additional users.
9. When all users have been added Click Save & apply.