User`s guide

User Access for Power Controller
Chapter 14 Power Controller 198
User Access for Power Controller
The Digi Passport unit can be configured to allow all or specific users
access to the power controller feature, as well as restricting specific users
to the power controller feature. User Access is configured on an per-outlet
basis. User Access to a serial device that is connected to the power
controller in configured under Serial Port > Configuration > Port # >
User Access.
Configure to Allow Specific Users Access
To configure the Digi Passport unit for specific users, deselect access for
<<Everyone>> and add specific user and access as in the following steps.
1. Log in to the Digi Passport unit (username root, password dbps)
2. Click Power Controller > Configuration > Outlets > outlet number to
configure.
3. Select the port to configure to the outlet. If it is a non-serial device,
select None.
4. Edit the outlet title. If there is a serial port, the port title will appear and
cannot be edited from this screen.
5. Click Save & apply.
6. Under Everyone, deselect the type of power access and click Save to
flash.
7. Enter the user that will have access and check the Access type: Port is
access to the port. Monitor is access to sniff. Power is access to the
power management.
8. Click Save to flash. Repeat steps 7 and 8 for additional users.
9. Click Save & apply after all users have been entered.