User`s guide

Configure Outlets
Chapter 14 Power Controller 196
Configure Outlets
To configure the power supplied to the device from the power controller,
follow these steps.
1. Under Power controller, click Outlets.
2. Click the outlet number to configure.
3. Select the serial port number that controls the device connected to the
Digi Passport unit (if any). If the port number has a title, it will appear.
To add a title or change the existing title, go to
Serial port > Configuration and select the port number to be changed.
Enter the title and click Save & apply. To continue, go to Power
Controller > Configuration > Title > Outlets and select the appropriate
outlet.
4. If not selecting a serial port number, user access parameters can be
changed on this page. Enter the User Access Control parameters - see
"User Access for Power Controller" on page 198.
5. Click Save to flash and repeat steps 2- 4 for each outlet to configure.