User`s guide

Use freeKVM with Remote Desktop Protocol
Chapter 11 Configure and Use freeKVM 170
Use freeKVM with Remote Desktop Protocol
This section describes how to configure freeKVM with Remote Desktop
Protocol, and connect to a system through freeKVM using Remote Desktop
Protocol.
Configure freeKVM with Remote Desktop Protocol
To set up freeKVM with Remote Desktop protocol, follow this procedure.
Note: When using Remote Desktop configuration and automatic IP
address detection is desired, configure the host mode for the port to MS
SAC console before configuring the freeKVM feature for the port. For
more information, see "Set Up the Digi Passport Unit for SAC Support" on
page 166.
1. Access the Digi Passport Web interface and log in.
2. Select Serial Port > Configuration. This window opens:
3. Select the port to configure, then click the freeKVM link. (In this
example, port 1 is selected.) A window similar to this one opens,
showing the serial port number and title: