User`s guide

Set Up the Digi Passport Unit for SAC Support
Chapter 10 Microsoft SAC Support 166
Set Up the Digi Passport Unit for SAC Support
To set up a serial port to provide access to the Windows Server 2003
console port, do the following:
1. Enter the IP address of the Digi Passport unit in the address bar of a
web browser to access the web interface.
2. Select Serial port > Configuration.
3. Select a port.
4. Select Host mode configuration. The Host mode configuration page
is displayed.
5. Set the Host mode to Console server and the Type of console server to
MS SAC -English (or International) console as shown in the following
figure.
6. Set other fields as appropriate.
7. Click Save & apply.
8. Configure serial port communication settings:
• Select Serial port parameters from the menu.
• Adjust settings as required. This includes ensuring that the Baud
rate matches the setting on the Windows Server 2003 serial port
and Flow control is set to None. Ignore the DTR behavior field.
When done, click Save & apply.