User`s guide

Dell Remote Access Controller (DRAC)
Chapter 7 Service Processors 137
6. Select Remote port parameters.
Enter the remote port parameters:
• Destination IP address: The address of the server to monitor.
Generally this will be the address assigned to the DRAC
management channel.
• Destination port: normally 22 for SSH or 23 for Telnet, but these
may vary on individual servers.
• Protocol: The protocol to be used on the port. Normally, the
protocol is SSH, but Telnet or RawTCP can be used if enabled on
the server.
• SMASH: Enables or disables use of the SMASH (Systems
Management Architecture for Server Hardware).
• Allow unattended continuous connection: If Enabled, when the
connection is lost, it is reestablished automatically. Enabling this
setting also enables the Automatic login setting and additional
login settings.
• Automatic login: whether the specified user should be
automatically logged in.
• User name: A user configured on the server with access to DRAC.
• Password: Supply and confirm the password for the above user.
• Reestablishment interval value: The time, in seconds, after which
a lost connection will be reestablished. The default is 5 seconds.
Click Save and apply.