User`s guide

Intelligent Platform Management Interface (IPMI)
Chapter 7 Service Processors 123
3. Select Remote port parameters from the main configuration page. The
remote port settings are displayed.
• Destination IP: The address of the server to monitor. Generally, this
is the address assigned to the BMC (Baseboard Management
Controller).
• Destination port. Normally, 623 is the port used for IPMI, but this
may vary on individual servers.
• Protocol: Select the protocol. RMCP+ is the protocol used for SOL.
• OEM type: Set to None in most cases. Use Intel IPMI 2.0 BMC only
if the server has an actual Intel 2.0 BMC.
When done, click Save to Flash.