User`s guide

Configure Alerts for Automatic Device Recognition (ADR)
Chapter 6 Alerts and Notifications 119
Configure Alerts for Automatic Device Recognition (ADR)
Before configuring the alerts for Automatic Device Recognition (ADR),
make sure the sure the port for ADR has been configured, as described in
"Configure Automatic Detection" on page 77.
1. Enter the IP address of the Digi Passport unit in the address bar of a
web browser to access the web interface.
2. Under the Serial Port heading, Click Configuration.
3. Select All > Alert Configuration or port number > Alert
Configuration.
4. Follow the Email Alert steps to configure the email alert or follow the
SMTP Notification to configure SMTP.
5. Complete configuration and click Save & apply.
Email Alert SMTP Notification
1. Enable Email Alert for active
detection.
2. Enter the Title of email.
3. Enter Name and email address
where the email should be sent.
1. Enable Active detection trap.
2. Configure the trap receiver by one of the
following ways:
- Select Use global SNMP configuration.
OR
- Enter the IP address of the trap receiver, the
SNMP trap community and select the version.