User`s guide

Manage SNMP configuration
Chapter 6 Alerts and Notifications 116
6. Select the Trap receiver enable/disable checkbox, then select v3
from the Version menu. The Trap receiver settings -1 page is
displayed:
Enter settings:
• IP address: Enter the IP address of the Trap receiver.
• User name: Fill in the User name; this value is the same user from
the SNMPv3 software.
• Select the Security level. Additional security level settings are
displayed, shown below. Use the same steps as in the Access
control settings section for the Authentication and Privacy
Protocols and their passwords.
• Engine ID: This value is supplied by the SNMPv3 software. Delete
the spaces from the original engine ID.