User`s guide

Configure SNMP v1 or v2
Chapter 6 Alerts and Notifications 111
Configure SNMP v1 or v2
To configure the Digi Passport unit for SNMP do the following:
1. Access the Digi Passport unit’s web interface.
2. Select Network > SNMP configuration.
3. In the MIB-II system objects section, enter MIB-II information as needed
and enable authentication traps by selecting Yes under
EnableAuthenTrap. Enable other SNMP traps as needed.
Important: Trap values override all other configuration information,
meaning all other authentication failure traps can be disabled with this
setting.
• sysContact: Identity of the contact person managing the MIB-II
system.
• sysName: The name identifying the system. By convention, this is
the fully qualified domain name of the Digi Passport unit; for
example, [e-mail].
• sysLocation: The physical location of the unit, for example, Room
264 or Engineering Lab.
• sysService (Read only): A series of values, separated by commas,
indicating the set of services the system provides. By default, the
Digi Passport unit only supports Application (7) service level.
• EnablePowerOnTrap: Whether the SNMP agent generates a trap
each time the Digi Passport unit is started.
• EnableAuthenTrap: Whether the SNMP agent process is permitted
to generate authentication failure traps.
• EnableLinkUpTrap: Whether the SNMP agent generates a trap
each time the network connection comes up.
• EnableLinkDownTrap: Whether the SNMP agent generates a trap
each time the network connection goes down.
• EnableLoginTrap: Whether the SNMP agent generates a trap for
each login.
4. Enter Access control settings.
• IP Address: Defines what applications can access the Digi
Passport unit’s SNMP agent to exchange information and control
actions. If no IP addresses are listed, any application can access the
SNMP agent.
• Community: The options are public or private; this value must
match the string used in the SNMP software.
• Permissions: The options are Read only or Read/Write.