User`s guide

Setting Additional Traps at the Port Level
Chapter 6 Alerts and Notifications 110
Setting Additional Traps at the Port Level
Additional traps can be set at the port level. The table shows where the trap
is located in the serial port configuration settings in the web interface (in
Serial port > Configuration), the trap name, and the trap functions.
The MIBs for applicable to the Digi Passport unit are on the Passport CD
and at http://www.digi.com/support/ under Digi Passport utilities.
Trap Location Trap Name Function
Port access menu Port login trap Notify about any login action to the port access
menu (succeed and fail).
Alert configuration Port login trap Notify about login to this specific port (succeed and
fail) (only available if host mode is set to "Console
server").
Alert configuration Device connection trap Notify about a change of the DTR signal line (only
available if host mode is set to "Console server").
Alert configuration Active detection trap Notify about changes in the device's response to
the probe string (see also "Discovering and
Configuring the Digi Passport unit" on page 14,
only available if host mode is set to "Console
server").
Alert configuration Dial-in modem test trap Notify about modem test (succeed and fail) (only
available if host mode is set to "Dial-in modem").
Port event handling Keyword notification trap Notify about the occurrence of a keyword in the
port log (only available if host mode is set to
"Console server").