User`s guide

Configure Remote Ports
Chapter 5 Configure Ports 104
4. The serial port Basic configuration page is displayed, with several
additional parameters for configuring remote ports.
Enter the remote port settings:
• Remote port destination IP: The IP address of the remote device.
• Remote port destination port (0-65535): The port number on the
remote device.
• Remote port protocol: The communications protocol used to
communicate with the remote device: Telnet, SSH, or RawTCP.
All other settings of the remote port are equivalent to the settings of a local
serial port.
To use a Digi PortServer TS 2 as a remote device, configure as follows: IP
address as assigned, IP port 2001 for port 1 or 2002 for port 2, and Telnet or
port 2501/ 2502 when using SSH as protocol.
5. Click Save & apply to confirm selections. A confirmation message is
displayed.