User manual

Configuration through the web interface
74
Change the IP address from the web interface, as needed
Normally, IP addresses are assigned to Digi devices either through DHCP or the Digi
Device Setup Wizard.
This procedure assumes that the Digi device already has an IP address and you simply
want to change it.
1 Open a web browser and enter the Digi device’s current IP address in the URL
address bar.
2 If security is enabled for the Digi device, a login prompt is displayed. Enter the user
name and password for the device. The default username is root and the default
password is dbps. If these defaults do not work, contact the system administrator
who set up the device.
3 Click Network to access the Network Configuration page.
4 On the IP Settings page, select Use the following IP address.
5 Enter an IP address (and other network settings), then click Apply to save the
configuration.