User manual

169
Configure Digi devices
Configuration through Simple Network Management Protocol (SNMP)
Configuring Digi devices through Simple Network Management protocol uses a subset of
standard MIBs for network and serial configuration, plus several Digi enterprise MIBs for
device identification and alarm handling. These MIBs are listed and described on page 59,
and must be loaded into a network management station (NMS). The standard and Digi
Enterprise MIBs allow for very basic network and serial configuration. For more detailed
configuration settings, use the command-line interface or web interface instead.
Some elements of SNMP configuration can only be configured from the web interface or
command line, such as the setting to send alarms as SNMP traps. In the web interface, this
setting is located at Configuration > Alarms > alarm > Alarm Destinations > Send
SNMP trap to following destination when alarm occurs. See "Configure alarms" on
page 149. In the command-line interface, this setting is configured by the set alarm
option type=snmptrap. See the set alarm command description in the Connect Family
Command Reference.
For more information on SNMP as a device interface, see pages 32 and 58. For
information on SNMP as a monitoring interface, see page 208.