User manual

Configuration through the web interface
120
Set mobile configuration settings to factory defaults
The Set to Defaults button on the Mobile Configuration page sets all the mobile settings
to factory defaults and sets the Service Provider selection back to deselected.
Mobile service provider settings
The Mobile Service Provider settings part of the screen identifies the service provider to
use in connecting to the mobile network. The information displayed varies by Digi
Cellular Family product and whether the remote service provider is GSM- or CDMA-
based. Settings that may be displayed on this screen include:
 Service Provider: For GSM-based mobile service providers, this is the service
provider to use in connecting to the mobile network. The service provider must
match the provider that supplied the SIM card.This must match the provider
that supplied the SIM card. (Not displayed for CDMA products.)
 Service Plan: For GSM-based mobile service providers, this is the service plan
to use in connecting to the mobile network. This setting must match the plan
that the service provider has supplied to you. This is also sometimes known as
the APN (Access Point Name).
 Username and Password: For GSM-based mobile service providers, these
settings are the username and password of the mobile connection needed to
access the mobile network.
 Device provisioning state: For CDMA-based mobile service providers, the
text below the Service Provider selection list states whether the device has
already been provisioned. Clicking the Provision Device button launches a
wizard for provisioning the device. Mobile device provisioning is described
next.