User manual

Chapter 18 Configuring Power Over the Serial Ports 77
instructions to reset.
From the command line use the two examples below for additional
information.
display circuitbreaker
Display the status of the circuit breaker
set configuration circuitbreaker=reset
Reset the circuit breaker
Note: set configuration print will also give the status of the circuitbreaker state.
Serial Power Table
Use this table for summary information for a serial power setup.
.
Quick Summary
Table for Setup of
Serial Power
DTR Power RI Power
OUT OUT IN
Switch Settings
DTR setting DTR ON DTR OFF DTR OFF
Ports Allowed 1, 2, 3, 4
1*, 2, 3, 4
*unless port 1 is used
for power in
1
Jumper Pin Settings
P-6 jumper on pins
2 & 3
(Factory Default)
P-6 jumper on pins
2 & 3
(Factory Default)
P-6 jumper on pins
1 & 2
Power Budget
9v @ up to 100mA
one watt
5v @ up to 200 mA
one watt
9 -30 v @ up to
525mA (max)