User manual

Chapter 11 Configuring IP Routing 55
set forwarding state=active poisonreverse=on splithorizon=on
set user name=link1...netrouting=off
Configuring Proxy ARP
This section describes how to configure device server for Proxy ARP.
Related Information
See the set forwarding command in the Digi One/PortServer TS Command
Reference.
Starting Point
This procedure assumes that you have signed on as root and have or will
configure modems, modem scripts, devices, and filters for routes that use
serial lines.
Procedure
1. Configure the links over which packets will be routed using a set user
command. This command must specify (on the ipaddr field) a specific
IP address for the remote system using the Proxy ARP service.
2. Configure device server for Proxy ARP by supplying a set forwarding
command that specifies the following:
• state=passive
• proxyarp=on
Example
In this example, device server provides Proxy ARP services to a remote
host.
set user name=link1...ipaddr=187.155.24.11
set forwarding state=passive proxyarp=on
Digi Device
Router
192.150.75.0
187.100.46.9
PPP
Digi Device
187.155.24.0
PPP
187.155.24.11