User manual

T1 Modem Bank
40
To run the setup program, insert the setup disk (part no. 40001468) into the drive and run SETUP.EXE.
Setup will perform the following steps:
1. Install local and remote management support files.
2. Install and run the ConfigWizard configuration utility.
3. Install and run the QuickManager management application.
4. Copy the SNMP MIBS (RFC1406, RFC1659 and DIGIT1E1. MIB).
5. Optionally install the Digi SNMP Proxy Agent.
When setup is complete, see the section “Configuring via QuickManager” on page 41.
Remote System Installation
Remote systems are systems running Windows NT or Windows 95 which will be used to remotely manage a host
system’s T1 Modem Banks. Using QuickManager, Windows 95 remote systems can manage only host systems that
are running Windows NT Server.
To run the setup program, insert the setup disk (part no. 40001468) into the driver and run SETUP.EXE.
Setup will perform the following steps:
1. Install the QuickManager management application.
2. Copy the SNMP MIBS (RFC1406, RFC1659 and DIGIT1E1.MIB).
When setup is complete, see the section “Configuring via QuickManager” on page 41.