User manual

T1 Modem Bank
36
Configuring the T1 Modem Banks
• The instructions for configuring and managing T1 Modem Banks with QuickManager are in “Configuring via
QuickManager” on page 41.
• Configuring the T1 Modem Banks with the DGT1CFG.NLM utility is described in this section.
Although the DGT1CFG.NLM utility will configure the T1 Modem Banks, it can not perform
management functions like advanced configuration, monitoring, and testing. For complete
management capability of your T1 Modem Banks, you must install and use QuickManager.
1. Make sure all T1 Modem Banks are powered on and display AC on their display panels.
2. Enter the following command:
load dgt1cfg.nlm
When the main menu appears, use the arrow keys to select the EPC/X host adapter that is connected to the T1
Modem Banks you wish to configure. (See Figure 17 for an example screen). Note that the field “#T1 Banks”
indicates how many modem banks are connected to that EPC/X host adapter.
Figure 17 Main Screen
All T1 Modem Banks should be ON and in the AC state before you select a board. If the T1
Modem Banks are not in the AC state, default parameters will initially be displayed, and any
changes you make can not be saved. Instead, the default parameters will be saved. If the T1
Modem Banks are not in the AC state, see the section titled “POST Failure” on page 30 for
instructions.