User manual

T1 Modem Bank

6. Place the cursor on “Dual-Ported Mem Address” and press <Enter>. A screen similar to the following will

appear:

The following address choices are available:

Below 1 Megabyte:

80000h 88000h 90000h 98000h

A0000h A8000h B0000h B8000h

C0000h C8000h D0000h D8000h

E0000h E8000h F0000h F8000h

Above 1 Megabyte:

F0000000h F1000000h F2000000h F3000000h

F4000000h F5000000h F6000000h F7000000h

F8000000h F9000000h FA000000hFB000000h

FC000000h FD000000hFE000000h FF000000h

* Although there are 16 choices offered for memory start addresses below 1 megabyte, a limited number of these

choices is likely to be available. Of the 16, the best choices are probably D0000 and D8000. See Appendix A

on page 85 for more information.

Multiple EISA EPC/X host adapters may share the same addresses.

7. Use the cursor keys to select one of the listed addresses, or press <Enter> to accept what the configuration pro-

gram has chosen. Write this address down—you will need to know it when installing the device driver soft-

ware.

8. Leave the Dual-Port Mem Enbl/Dsbl at “Disabled”.

9. Leave the Interrupt Configuration at “Disabled”.

10. Pull down the SYSTEM menu, and choose “Exit”. Make sure that you SAVE the new configuration as the

program suggests.

11. Go to “Connecting the EPC/X Host Adapter to the T1 Modem Banks” on page 25.