User manual

Appendix F 125
+FDR Begin or continue Phase C Receive Data.
Command syntax: +FDR
This command will initiate a transition to Phase C data reception.
+FDT Begin Phase C Data Transmission.
Command syntax: +FDT
This command prefixes Phase C data transmission.
+FECM Error Correction Mode Control.
Command syntax: +FECM=<value>
0: Error correcting mode disabled.
+FET Transmit Page Punctuation.
Command syntax: +FET=<ppm>
0: [PPS-]MPS Another page next, same document.
1: [PPS-]EOM Another document next.
2: [PPS-]EOP No more pages or documents.
3: PPS-NULL Another partial page next.
4: [PPS-]PRI-MPS Another page, procedure interrupt.
5: [PPS-]PRI-EOM Another document, procedure interrupt.
6: [PPS-]PRI-EOP All done, procedure interrupt.
7: CTC Continue to correct.
This command is used to punctuate page and document transmission, after one or more +FDT commands.
+FK Session Termination.
Command syntax: +FK
This command causes the modem to terminate the session in an orderly manner.
+FLID Local ID String.
Command syntax: +FLID=”<local ID string>”
Valid values: ASCII string can be up to 20 characters.
Response syntax: +FLID=?
Return value: (20), (32-127)
+FLNFC Page Length Format Conversion.
Command syntax: +FLNFC=<value>
0: Disables mismatch checking. The DTE must check the +FDCS:LN subparameter, and transfer
matching data.
+FLPL Indicate Document to Poll.
Command syntax: +FLPL=<value>
0: Indicates that the DTE has no document to poll.
+FMDL Request Model Identification.
Command syntax: +FMDL?
Response value: The information text cannot exceed 2048 characters.
This command causes the modem to send one or more lines of information text which is used to identify the
product.