User manual

72 Chapter 12 Reference and Certifications
• Installation of inside wire may bring you close to electrical wire,
conduit, terminals and other electrical facilities. Extreme caution
must be used to avoid electrical shock from such facilities. You must
avoid contact with all such facilities.
• Telephone wiring must be at least 6 feet from bare power wiring or
lightning rods and associated wires, and at least 6 inches from other
wire (antenna wires, doorbell wires, wires from transformers to neon
signs), steam or hot water pipes, and heating ducts.
• Before working with existing inside wiring, check all electrical outlets
for a square telephone dial light transformer and unplug it from the
electrical outlet. Failure to unplug all telephone transformers can
cause electrical shock.
• Do not place a jack where it would allow a person to use the
telephone while in a bathtub, shower, swimming pool, or similar
hazardous location.
• Protectors and grounding wire placed by the service provider must
not be connected to, removed, or modified by the customer.
Specifications
PortServer TS 8/16
Do not work on your telephone wiring if you wear a
pacemaker. Telephone lines carry electrical current.
Important!
Do not touch uninsulated telephone wiring if lightning is
likely!
External Wiring
Any external communications wiring you may install needs to
be constructed to all relevant electrical codes. In the United
States this is the National Electrical Code Article 800.
Contact a licensed electrician for details.
Power Requirements
(Standard Models)
2-contact barrel
connector
+9 to +30 VDC 525 mA (max) external power
supply
Environmental PortServer TS 8 PortServer TS 16
Ambient
temperature
0 to 50° Celsius
32 to 131° Fahrenheit
Relative
humidity
5% to 90% non-condensing