User manual

set ddns
Chapter 2 Command Descriptions 95
nochg
Specifies that there should be no change to service setting from the
current selection for wildcards in the DDNS settings at the
DynDNS.org Web site.
Examples This example shows “set ddns” being used to display the current status of
the Dynamic DNS service:
#> set ddns
DDNS Service Update Configuration :
service : dyndnsorg
ddconntype : securehttp
ddsystem : statdns
ddusername : "test"
ddpassword : (Not shown for security reasons)
ddhostname : "test-static.dnsalias.com,test-static.dnsalias.org"
ddwildcard : nochg
Current IP address: 166.213.228.220 (ppp1)
Most recent DDNS service update status:
Service : DynDNS.org
IP address reported : 166.213.228.220
Update status : successful
Result information : [good] The update was successful.
Raw result data :
good 166.213.228.220
good 166.213.228.220
Most recent DDNS service update log message:
IP address for "ppp1" is now 166.213.228.220, but no DDNS update is needed
last reported IP address is unchanged).
See also • "display" on page 27.
• "revert" on page 61.
• "show" on page 249.
• Dynamic DNS resources available from your service provider, such as
glossary definitions, FAQs, knowledge base articles, and tips for
managing your account.