User manual

Quick Reference for Configuring Features
Chapter 1 Introduction 9
IP Forwarding and Network Address Translation
(NAT)
"set forwarding" on page 109.
"set nat" on page 146.
IP pass-through "set passthrough" on page 153
Mobile (Cellular) features:
• Provisioning CDMA cellular modules To display existing provisioning parameters:
“display provisioning” -- see "display" on page 27
To provision the CDMA module: "provision" on page 53
• Mobile service provider and connection
settings
The only mobile connection setting that can be set from
the command line is the inactivity timeout,
(“set pppoutbound (rx_idle_timeout=timeout.)
The Inactivity timeout specifies the time, in seconds, after
which if no data has received over the link, the mobile
connection will be disconnected and re-established.
"set pppoutbound" on page 166.
• SureLink™ Settings "set surelink" on page 202.
Multiple Electrical Interface (MEI) "set switches" on page 208
Point to Point Protocol (PPP) "set pppoutbound" on page 166.
Port buffering "display buffers" on page 37.
"set buffer" on page 90.
Port profiles: sets of preconfigured serial-port
settings for a particular use
"set profile" on page 172.
Python
®
program storage and execution on Digi
devices
To learn about the Python programming language and
writing programs: see the Digi Python Programming
Guide.
To configure Python programs to execute when the Digi
device boots: "set python" on page 183.
To manually execute a Python program from the command
line: "python" on page 58.
RCI over Serial "set rciserial" on page 184.
RealPort (COM port redirection) configuration "set realport" on page 185.
See also the RealPort Installation Guide.
Remote access through VNC (Virtual Network
Computing) protocol
"set vncclient" on page 226.
Remote login (rlogin) "rlogin" on page 66.
Reverting configuration settings "revert" on page 61.
RTS Toggle "set rtstoggle" on page 187.
Feature/Task Commands