User manual

set alarm
78 Chapter 2 Command Descriptions
Mobile temperature-based alarm options
These options for setting alarms based on the radio’s reported temperature
are supported in Digi Cellular Family products only. Note that temperature-
based options are not available with all radios. To determine if your radio
supports these alarms, use the “display mobile” command. If the
temperature is displayed, it can be monitored.
mode=mobile_temp
Sets the alarm to mobile temperature mode.
optimal_alarms_enabled={yes|no}
If optimal alarms are enabled, an optimal alarm will also be sent when the
temperature returns to a value that is below the specified threshold
Mobile service-based alarm options
These options for setting alarms based on the service state of the radio are
supported in Digi Cellular Family products only. Note that some service-
based options are not available with all radios. To determine if your radio
supports these alarms, use the “display mobile” command. If the service is
displayed, it can be monitored.
mode=1xevdo_unavail
Sets the alarm to monitor 1xEV-DO service.
mode=mobile_unavail
Sets the alarm to monitor registration status. Any registration status other
than “Registered (Home Network)” is considered to be a mobile
unavailable status.
time=time
The time in minutes that the specified service has been unavailable.
optimal_alarms_enabled={yes|no}
If optimal alarms are enabled, an optimal alarm will also be sent when the
service being monitored is reestablished. Default is no.
Mobile-oriented configuration change alarm options
This option for setting alarms based on a change to any of the mobile-
oriented configurations is supported in the Digi Cellular Family products
only. The following configuration items are monitored: PPP settings (set
pppoutbound) associated with the mobile radio; PPP Bridge settings (set
passthrough); Mobile settings (set surelink); or mobile provisioning, manual
or IOTA.
mode=config_change
Sets the alarm to monitor mobile configuration changes.