User manual

set alarm
Chapter 2 Command Descriptions 77
mode=ecio_1xevdo
Sets the alarm to 1xEV-DO Ec/Io signal-strength mode for a CDMA radio.
signal_strength_threshold=threshold
The threshold average signal strength., This is measured in dBm for
rssi_gsm, rssi_1xrtt, and rssi_1xevdo (typically -120 dBm to -40 dBm)
and dB for ecio_1xrtt and ecio_1xevdo (typically -24 dB to -2 dB).
Note that “0 dB” reported by a “display mobile” command when there is
no signal strength should properly be interpreted as the minimum value,
which is -120 dBm or -24 dB.
time=time
The time in minutes that the average signal strength stays below the
threshold specified on the “signal_strength_threshold” option.
optimal_alarms_enabled={yes|no}
If optimal alarms are enabled, an optimal alarm will also be sent when the
signal strength returns to a value that is above the specified threshold.
Default is no.
Cellular data traffic-based alarm options
These options for setting alarms based on cellular data traffic are
supported in Digi Cellular Family products only.
mode=cell_data
Sets the alarm to cellular-data mode.
cell_data=byte count threshold
The number of bytes of cellular data to be counted before triggering an
alarm.
cell_data_type={receive|transmit|total}
The type of cellular data to be counted.
receive
Data received by the Digi Cellular device.
transmit
Data transmitted by the Digi Cellular device.
total
The total data received and transmitted the Digi Cellular device.
time=max time
The time, in minutes, during which bytes of cellular data are counted.