User manual

provision
Chapter 2 Command Descriptions 57
IOTA provisioning parameters
type=iota
Specifies that the CDMA module is being provisioned using the IOTA
method.
spc=service programming code (MSL)
A six-digit number required to program CDMA module parameters.
mdn=mobile directory number
The phone number of the CDMA module.
min=mobile ID number
How the CDMA module is identified in the cellular network. Depending
on the cellular provider, this number may be the same as the mobile
directory number.
OTASP provisioning parameters
type=otasp
Specifies that the CDMA module is being provisioned using the
OTASP method.
otaspnumber=OTASP number for example, *228
A phone number for initiating an OTASP provisioning session. This
number typically begins with *228, for example *22899.
See also • "display" on page 27. The “display provisioning” command displays the
currently configured parameters in the CDMA cellular module.
• The Digi Cellular Family User’s Guide’s section on Mobile Device
Provisioning. That discussion describes provisioning through a Wizard
and the Web user interface, but the same concepts apply to command-
line based provisioning.
• "set pppoutbound" on page 166
• "who" on page 258
• "kill" on page 49