User manual

display
32 Chapter 2 Command Descriptions
Output This section describe and interprets selected information and statistics
output by the “display” command.
Information returned by “display pppstats”
The “display pppstats” displays status and activity information for a PPP
link, and SureLink statistics.
This information is specific to Digi Cellular Family products.
PPP status and activity information
In these status and activity values, a “session” is a PPP session. The
session statistics are reset to zero at the start of a new PPP link. The “total”
statistics are the accumulated totals for all sessions since the device
booted.
state
The current state of the PPP link. “Active” indicates that a PPP link is up.
“Inactive” means the PPP link is down. Inactive is indicated when the link
is coming up, or going down.
ip address
The PPP WAN IP address of the Digi device. This is the IP address used
to communicate over the cellular network. This IP address is assigned by
the carrier most of the time, but can also be given to the network by the
Digi device.
primary dns addr
secondary dns addr
These are addresses for the DNS nameservers, used for performing
name lookups. These DNS addresses are assigned by the carrier most
of the time, but can also be assigned by users.
tx bytes
rx bytes
The total number of bytes transmitted (tx) or received (rx) over the PPP
link since the last reboot.
session tx bytes
session rx bytes
The number of bytes transmitted (tx) or received (rx) over the PPP link in
the current PPP session.