User manual

vpn
256 Chapter 2 Command Descriptions
vpn
Devices
supported
This command is supported in Digi Cellular Family products only, except
Digi Connect WAN.
Purpose Manages and displays the status of a Virtual Private Network (VPN) tunnel.
Required
permissions
For Digi Connect products with two or more users, permissions must be set
to “set permissions vpn=execute” to use this command. See
"set permissions" on page 157 for details on setting user permissions for
commands.
Syntax vpn [status|connect|disconnect]
[index=1-2)]
[name=tunnel name]
Options status|connect|disconnect
Specifies the action performed by the command. Note that a data
connection must be attempted before the VPN tunnel will actually be
brought up.
status
Display the status of the VPN tunnel.
connect
Enable the VPN tunnel.
disconnect
Disconnect the VPN tunnel.
index=1-2
Identifies the VPN tunnel.
name=tunnel name
The name of the tunnel.
Example
Display VPN tunnel status
#> vpn status
VPN Tunnel #1 Status :
name : Tunnel 1
mode : isakmp
status : down
remote address: : 65.214.122.53
mobile address: : not connected
VPN Tunnel #2 Status :
name : Tunnel 2
mode : disabled