User manual

show
252 Chapter 2 Command Descriptions
port=range
Identifies a particular serial port. Optional on a single-port device.
range=range
A configuration table entry or range of entries.
Examples Display network configuration settings
#> show network
Network configuration:
MAC Address : 00:40:9D:24:8B:B3
Currently in use by
the network stack Stored configuration
-------------------- -------------------
ipaddress : 10.8.16.8 192.168.4.25
submask : 255.255.0.0 255.255.0.0
gateway : 10.8.1.1 0.0.0.0
static : off off
dhcp : supplied IP address on
autoip : on on
keepalive idle : 7200 7200
probe count : 9 9
probe interval : 75 75
garbage byte : on on
override dhcp : off off
dns1 : 10.10.8.62 0.0.0.0
dns2 : 10.10.8.64 0.0.0.0
rto_min : 1000 1000
rto_max : 10 10
arp_ttl : 15 15
garp : 3600 3600
Display current alarm settings
#> show alarm
Display settings for a particular user
#> show user range=3