User manual

set vncclient
Chapter 2 Command Descriptions 227
keepalive={on|off}
Indicates whether or not TCP keep-alives will be sent while connected to
the VNC server. Keep-alives help to detect when a connection has been
lost. TCP keep-alive parameters (such as how often to send them) are
configured globally.
Example
#> set vncclient state=on server=10.20.1.107 port=5900 password=dnf10
reconnect=10 shared=on localcursor=on
See also • "revert" on page 61.
• "set service" on page 191. The VNC Client Listen Daemon and VNC
Server services are enabled and disabled by the “set service”
command.
• "set video" on page 225.
• "show" on page 249.
• The ConnectPort Display User’s Guide’s section titled “Configure
Remote Access (VNC Client) Settings.”