User manual

set user
220 Chapter 2 Command Descriptions
set user
Devices
supported
This command is supported in all Digi Connect products.
Purpose Used to:
• Add users for access to a Digi Connect device. The number of users
that can be defined varies by Digi Connect device. To determine the
number of users allowed for your Digi Connect device, enter “set user”
or “show user”.
• Associate a user with a group. A user can be associated with up to two
groups.
• Disassociate a user from a group.
• Remove users.
• Change user configuration attributes.
• Display user configuration attributes.
• Load an SSH public key, and, for single-user model products, unload a
public key.
Required
permissions
For Digi Connect products with two or more users, to use this command,
permissions must be set to one of the following:
• For a user to display user configuration attributes:
“set permissions s-user=read”
• For a user to display and set user configuration attributes:
“set permissions s-user=rw”
See "set permissions" on page 157 for details on setting user permissions
for commands.
Default permissions for a new user
When a new user is created, it is given a set of default permissions. Once a
user is created, an administrator can adjust permissions up or down as
needed. Default permissions for a new user are as follows. For more
information on user permissions, see "set permissions" on page 157.
• none: for backup, boot, connect, display, buffers, kill, s-alarm, s-gpio,
s-permissions, s-pmodem, s-rciserial, s-snmp, status, webui, filesys,
s-idle, s-panic, revert-all, s-trace, s-wlan, s-menu, s-profile
• execute: For reconnect, rlogin, telnet, who, ping.
• read: access, s-ethernet, s-group, s-network, s-serial, s-service,
s-system, s-trane, s-user
• r-self: autoconnect, rtstoggle, tcpserial, udpserial
• rw-self: newpass