User manual

set udpserial
216 Chapter 2 Command Descriptions
set udpserial
Devices
supported
This command is supported in all Digi Connect products except Digi
Connect WAN and ConnectPort Display.
Purpose Use this command to set up the UDP serial feature, or display current UDP
serial settings.
The UDP serial feature allows data to be sent between the serial port and
one or more remote network destinations using the UDP protocol. When
this feature is enabled for a given serial port, data sent to the serial port will
be sent out to the configured destinations. Also any time data is sent to the
UDP serial service (IP port 2101) and the serial port is not being used by
another service, the data will be sent to the serial port.
Required
permissions
For Digi Connect products with two or more users, to use this command,
permissions must be set to one of the following:
• For a user to display the UDP serial settings for the line on which they
are logged in: “set permissions s-udpserial=r-self”
• For a user to display the UDP serial settings for any line:
“set permissions s-udpserial=read”
• For a user to display and set the UDP serial settings for the line on
which they are logged in: “set permissions s-udpserial=rw-self”
• For a user to display the UDP serial settings for any line, and set UDP
serial settings for the line on which the user is logged in:
“set permissions s-udpserial=w-self-r”
• For a user to display and set the UDP serial settings on any line:
“set permissions s-udpserial=rw”
See "set permissions" on page 157 for details on setting user permissions
for commands.
Syntax Set general UDP serial forwarding characteristics for a serial port
set udpserial port=range [state={on|off}]
[sendcount=bytes] [sendtime={0|time}]
[endpattern=string] [strippattern={on|off}]
[sid={on|off}] [sidstring=string}
[closetime=time]
Set UDP destinations for a given serial port
set udpserial port=range range=1-64 [description=string]
[active={on|off} [ipaddress=ip address}
[ipport=ip port]
Display current UDP serial settings
set udpserial [port=range [range=range]]