User manual

set tcpserial

214 Chapter 2 Command Descriptions

sendtime={0|1-65535ms}

Indicates that data from the serial port should be sent out to the network

after the given amount of time has past where no new data has arrived

from the serial port. This option only is valid when the “buffered” option is

“on.” A value of 0 (zero) disables this option. The default is 0.

endpattern=string

Indicates that data from the serial port should be sent out to the network

after the given endpattern string has been found in the data from the

serial port. This option only is valid when the “buffered” option is “on.” An

empty string disables this option.

The maximum length of this string is 16 characters, including escape

sequences for special characters. For more details on the escape

sequences, see "Entering Special Characters in String Values" on page

13. The maximum parsed length of this string is 4 characters. That is, this

string must reduce down to a 4-character string when the escape

sequences are processed.

strippattern={on|off}

This option corresponds with the “endpattern” option. When a valid

“endpattern” string is found, this option indicates whether the matching

string is stripped or kept in the data stream. The default is “off.”

Examples #> set tcpserial hangupdcd=off idletime=20

#> set tcpserial port=1 sid=on sidstring=”abc”

#> set tcpserial port=1 buffered=on sendtime=50 sendcount=512

#> set tcpserial