User manual

set socket_tunnel

Chapter 2 Command Descriptions 201

Options state={disabled|enabled

Enables or disables the configured socket tunnel.

timeout={0|seconds}] {0 is no timeout}

The timeout (specified in seconds) controls how long the tunnel will

remain connected when there is no tunnel traffic. If the timeout value is

zero, then no timeout is in effect and the socket tunnel will stay up until

some other event causes it to close.

from_hostname={name|ip address}

The initiating host: the hostname or IP address of the network device that

initiates the socket tunnel.

from_port=port number

The initiating port: the port number that the Digi device uses to listen for

the initial socket tunnel connection.

from_protocol={tcp|ssl}

The initiating protocol: the protocol used between the device that initiates

the socket tunnel and the Digi device. Currently, TCP and SSL are the

two supported protocols.

to_hostname={name|ip address}

The destination host: The hostname or IP address of the destination

network device.

to_port=port number

The destination port: the port number that the Digi device uses to make

a connection to the destination device.

to_protocol={tcp|ssl}

The destination protocol: the protocol used between Digi device and the

destination device. Currently, TCP and SSL are the two supported

protocols. This protocol does not need to be the same for both

connections.