User manual

set service
Chapter 2 Command Descriptions 197
Examples Disable service
#> set service range=1 state=off
Change the network port (ipport) of a service
#> set service range=1 ipport=500
Displaying the service table
In this example, the “set service” command displays the entire service
table.
#> set service
Displaying an entry in the service table
In this example, the “set service” command displays a range of entries in
the service table.
#> set service range=2-4
Allow outgoing data that is unacknowledged or less than maximum
segment size
#> set service ra=5 nodelay=on
See also • "revert" on page 61.
• "set network" on page 149.
• "set passthrough" on page 153 for information on network services and
applications that are enabled and disabled by default when a Digi
device is configured for IP passthrough.
• "show" on page 249.
• For descriptions of the Connectware Manager application and related
settings, see "set mgmtconnection" on page 137, "set mgmtglobal" on
page 140, and "set mgmtnetwork" on page 143.
• For more information on SureLink Link Integrity Monitoring tests, see
"set surelink" on page 202.