User manual

set service
Chapter 2 Command Descriptions 191
set service
Devices
supported
This command is supported in all Digi Connect products.
Purpose Used to:
• Enable and disable network services.
• Change the network port on which a given service listens.
• Display the entire service table, or an entry in the service table.
Caution on enabling and disabling services
Exercise caution in enabling and disabling network services, particularly
disabling them. Changing certain settings can render your Digi Connect
product inaccessible. For example, if you disable Advanced Digi Discovery
Protocol (ADDP), the device will not be discovered on a network, even if it
is actually connected. If you disable HTTP and HTTPS, the Web interface
can be disabled. Disabling basic services such as Telnet, Rlogin, etc. can
make the Command-Line interface inaccessible.
Required
permissions
For Digi Connect products with two or more users, permissions must be set
to “set permissions s-service=read” to display network service settings,
and “set permissions s-services=rw” to display and change network service
settings. See "set permissions" on page 157 for details on setting user
permissions for commands.
Syntax Enable/disable network services or change network port for service
set service [range=range]
[state={on|off}]
[ipport=network_port]
[keepalive={on|off}]
[nodelay={on|off}]
[delayed_ack=0-1000]
Display service table or entries in the table
set service [range=range]
Options range=range
Used to specify the index of the network service to which the rest of the
command’s options apply. For more information on using this option, see
"Index numbers and changing default port numbers" on page 196.
state={on|off}
Used to enable or disable a given network service.
ipport=network port
Used to change the network port on which a given network service
listens. See "Supported network services and their default network port
numbers" on page 193 for more information on the network services
available.