User manual

set rtstoggle
188 Chapter 2 Command Descriptions
predelay=delay
Specifies the time in milliseconds to wait after the RTS signal is turned on
before sending data. The range is 0 to 5000 milliseconds. The default is
0.
postdelay=delay
Specifies the time in milliseconds to wait after sending data before turning
off the RTS signal. The range is 0 to 5000 milliseconds. The default is 0.
Examples #> set rtstoggle state=on predelay=10
See also • "revert" on page 61.
• "show" on page 249.