User manual

set putty
Chapter 2 Command Descriptions 175
set putty
Devices
supported
This command is supported in ConnectPort Display devices only.
Purpose Configures terminal-emulation settings for ConnectPort Display, and
displays current terminal-emulation settings.
ConnectPort Display can emulate a terminal connected to a host/server
over a serial line or the network. When connected over the network
RealPort must be installed on the server. RealPort ports appear to
applications on the server as serial ports, but the data is redirected over the
network to the terminal. For more information on RealPort, see the
RealPort Installation Guide.
A ConnectPort Display device can emulate a terminal connected to a host/
server. Data sent from the host application is processed and displayed on
the terminal screen. A keyboard can also be used. If a keyboard is
connected to the terminal, the terminal data is sent to the host application
for it to process.
A reboot is required for the terminal-emulation settings to take effect.
Syntax Set general terminal emulator options
set putty [state={on|off}]
[width={80|132}]
[height=10-60]
[hostport={/com/0|/com/1|/vcom/0]
[keyboardport={/com/0|/com/1}]
[cursortype={none|block|underline|vertical}]
[blinkcursor={on|off}]
[blinktext={on|off}]
[backspaceisdelete={on|off}]
[lfimpliescr={on|off}]
[characterset=host charset]
Set key mappings - range required
set putty
[deletekeymaprange=1-32]
[keymaprange=1-32]
[inseq=00-FF]
[outseq=00-FF]
Display terminal emulation settings
set putty