User manual

set pppoutbound
166 Chapter 2 Command Descriptions
set pppoutbound
Devices
supported
This command is supported in Digi Cellular Family products only.
Purpose Configures Point-to-Point Protocol (PPP) outbound connections, or
displays current PPP outbound settings.
Required
permissions
For Digi Connect products with two or more users, to use this command,
permissions must be set to one of the following:
• For a user to display the pppoutbound settings:
“set permissions s-ppp=read”
• For a user to display and set pppoutbound settings:
“set permissions s-ppp=rw”
See "set permissions" on page 157 for details on setting user permissions
for commands.
Syntax Configure PPP outbound connections
set pppoutbound port=range
[state={enabled|disabled}]
[auth_method={none|PAP|CHAP|both}]
[passive={on|off}]
[remote_address={negotiated|ip address}]
[local_address={negotiated|ip address}]
[address_mask=ip address mask]
[default_gateway={yes|no}]
[protocol_compression={on|off}]
[address_compression={on|off}]
[header_compression={on|off}]
[lcp_keepalive={on|off}]
[lcp_ka_quiet_time=(10-86400 seconds)]
[lcp_ka_max_missed_replies={(2-255|0=ignore missed replies)}]
[asyncmap=hex string]
[chap_id=chap id]
[chap_key=chap key]
[pap_id=pap_id]
[pap_password=pap password]
[mru=256-1500]
[mtu=256-1500]
[n{1-4}=phone_number]
[redial_attempts=attempts]
[redial_delay=delay]
[rx_idle_timeout=timeout]
[tx_idle_timeout=timeout]
[init_script=chat script]
[dial_script=chat script]
[login_script=chat script]
[ipcp_dns_enabled={on|off}]
Display PPP outbound settings
set pppoutbound