User manual

set network
Chapter 2 Command Descriptions 149
set network
Devices
supported
This command is supported in all Digi Connect products.
Purpose Used to set general network configuration options and display current
network configuration options, including options for IP address settings,
TCP keep-alives, retransmissions of TCP packets, and ARP settings.
The “garp” and “rto_min.” options can be used for optimizing for latency at
the network level.
Required
permissions
For Digi Connect products with two or more users, permissions must be set
to “set permissions s-network=read” to display network configuration
attributes, and “set permissions s-network=rw” to display and set network
configuration attributes. See "set permissions" on page 157 for details on
setting user permissions for commands.
Syntax Set network configuration options
syntax: set network [ip address options]
[TCP keepalive options]
[TCP retransmit options]
[ARP options]
Where:
[ip address options]:
[ip=device ip address]
[submask=subnet mask]
[gateway=gateway ip address]
[static={on|off}]
[dhcp={on|off}]
[autoip=(on|off)
[dns1=primary dns server ip address]
[dns2=secondary dns server ip address]
[TCP keepalive options]:
[idle=10-86400] (seconds)
[probe_count=5-30]
[probe_interval=10-75] (seconds)
[TCP retransmit options]:
[rto_min=30-1000] (milliseconds)
[rto_max=1-240] (seconds)
[ARP options]:
[arp_ttl=1-20] (minutes)
[garp=30-3600] (seconds)
Display current network configuration options
set network