User manual

set mgmtnetwork
Chapter 2 Command Descriptions 143
set mgmtnetwork
Devices
supported
This command is supported in all products except Digi Connect ES and
ConnectPort Display.
Purpose The Connectware Manager server allows devices to be configured and
managed from remote locations. The “set mgmtnetwork” command
configures the network settings for the Digi device’s connection to the
Connectware Manager server so the device knows how to connect to the
server.
Required
permissions
For Digi Connect products with two or more users, to use this command,
permissions must be set to one of the following:
• For a user to display the Connectware Device Protocol network
settings: “set permissions s-mgmtnetwork =read”
• For a user to display and set Connectware Device Protocol network
settings: “set permissions s-mgmtnetwork =rw”
See "set permissions" on page 157 for details on setting user permissions
for commands.
Syntax Configure Connectware Manager network settings
set mgmtnetwork
[networktype={modemppp|ethernet|802.11}]
[connectionmethod={auto|none|mt|mdh|proxy}]
[proxyaddress=string]
[proxyport=port]
[proxylogin=string]
[proxypassword=string]
[proxypersistentconnection={on|off}]
[mtrxkeepalive=time]
[mttxkeepalive=time]
[mtwaitcount=count]
[mdhrxkeepalive=time]
[mdhtxkeepalive=time]
[mdhwaitcount=count]
Display Connectware Manager network settings
set mgmtnetwork
Options [networktype={modemppp|ethernet|802.11}
The type of network to which this command applies.
modemppp
A modem PPP network.
ethernet
An Ethernet network.
802.11
An 802.11 network.