User manual

set mgmtglobal
140 Chapter 2 Command Descriptions
set mgmtglobal
Devices
supported
This command is supported in all products except Digi Connect ES and
ConnectPort Display.
Purpose The Connectware Manager server allows devices to be configured and
managed from remote locations. This command is used to set or display
the Connectware Manager global settings, or revert the device ID to factory
settings.
Required
permissions
For Digi Connect products with two or more users, to use this command,
permissions must be set to one of the following:
• For a user to display the Connectware Device Protocol global settings:
“set permissions s-mgmtglobal=read”
• For a user to display and set Connectware Device Protocol global
settings: “set permissions s-mgmtglobal=rw”
See "set permissions" on page 157 for details on setting user permissions
for commands.
Syntax Configure Connectware Manager global settings
set mgmtglobal [deviceid={hex string}]
[rcicompressionenabled={on|off}]
[tcpnodelayenabled={on|off}]
[tcpkeepalivesenabled={on|off}]
[connidletimeout={none|timeout value}]
Display Connectware Manager global settings
set mgmtglobal
Revert the Device ID to factory settings
set mgmtglobal revertdeviceid
Options deviceid={hex string}
Used to specify the device ID. The device ID is 32 hexadecimal digits,
preceded by the characters “0x.”