User manual

set ia
Chapter 2 Command Descriptions 121
Configure destination tables and route entries (set ia table)
set ia table=range [table options]
[route=range [route options]]
[table options]:
state={on|off}
name=string
addroute=route index
removeroute=route index
moveroute=from_route_index,to_route_index
[route options]:
active={on|off}
connect={active|passive}
protaddr=protocol address range
type={discard|ip|mapto|nopath|serial}
protocol={modbusrtu|modbusascii|modbustcp}
port=serial port
transport={tcp|udp}
ipaddress=ip address
ipport=ip port
replaceip={on|add|sub|off}
mapto=protocol address
slavetimeout=10-99999 ms
chartimeout=3-99999 ms
idletimeout={0=disabled, 1-99999 seconds}
reconnecttimeout=0-99999 ms
Display current IA settings
To display current IA settings, the “show” command is recommended
instead of a “set ia” command with no options:
show ia all
Options Options for configuring serial-port connected devices (set ia serial)
serial=range
Specifies that the serial settings apply to the specified serial port or range
of serial ports. The default is port 1, and on a single-port device, entering
serial is the same as serial=1.
[serial options]
The serial settings, which include:
state={on|off}
Enables the IA serial settings. Setting to off risks the configuration
being deleted.
active={on|off}
To temporarily stop processing the serial port, set “active” to “off.” The
configuration will remain valid and saved.
type={master|slave}
Defines whether the serial device attached is acting as a master or a
slave.